Mass Home Comfort
Find contractors
HVAC · Erving, MA

HVAC in Erving, Massachusetts

Compare contractors serving Erving, Franklin County — call them directly, or send one request and let the ones who want the job come to you.

30 contractors serving Erving.

Contractors serving Erving

Claimed listings within 5 miles come first, then the rest by rating, then distance. Google ratings as of October 2026. How we list and rank contractors

Mass Save in ErvingEligible

Erving is in National Grid electric territory and fully Mass Save eligible. Whole-home cold-climate heat pump installs have typically qualified for up to $8,500 ($2,650 per ton) in recent rebate cycles; partial and single-zone mini-split installs usually land around $2,500–$6,000. A free Mass Save home energy assessment is the unlock for the larger rebates. Erving's older housing means the assessment almost always surfaces insulation, air-sealing, and sometimes knob-and-tube work. Mass Save weatherization rebates cover a large share of envelope work, and the 0% HEAT Loan up to $25,000 (effective January 1, 2025) is widely used for bundled projects.

Read next

HVAC in Erving — what to know

Permits in Erving

Massachusetts state code (780 CMR) requires a building permit for HVAC replacement, filed with the Erving building department. A separate electrical permit is required for new heat-pump circuits. Erving runs a small department; confirm inspection availability when scheduling. The Millers River, Keyup Brook, and adjacent wetlands put much of town inside Conservation Commission jurisdiction, and Notice of Intent filings under the Wetlands Protection Act are common for equipment pads or trenching.

Where a permit is required, HVAC work in Erving is filed with the Erving Building Department; see the Erving Building Department’s contact, portal and who pulls the permit on permits.llc.

Typical project cost

Erving HVAC costs sit near western-MA averages. A whole-home cold-climate heat pump retrofit typically runs $20,000–$36,000 before rebates; a single-zone ductless mini-split lands $4,500–$8,000; an oil boiler swap is usually $8,500–$13,000 with a new tank. Mill-village homes with shared walls or tight street frontage sometimes need creative line-set routing that adds $1,500–$4,000.

About Erving homes

Erving is a Franklin County town of about 1,631 people in roughly 757 housing units along the Millers River and Route 2 east of Greenfield. The median home is around 75 years old — older than most neighboring towns — reflecting the densely packed mill-village housing in Erving Center and along Route 2A, plus rural farmhouses and back-road camps along the Millers.

Natural gas service is essentially absent. Oil, propane, and wood dominate existing heating. The dense older housing in the village makes ductless mini-splits the dominant retrofit choice, while back-road homes more often go ducted.

Common questions — HVAC in Erving

Do Mass Save heat pump rebates apply in Erving?
Yes. Erving is served by an investor-owned electric utility, so homeowners qualify for the full Mass Save program: the whole-home heat pump rebate of $2,650 per ton (up to $8,500) when the heat pump becomes the only heating system, $1,125 per ton with a boiler or furnace kept as backup, and the 0 percent HEAT Loan up to $25,000. The equipment must be on the Mass Save qualified product list, and the whole-home rebate has weatherization conditions that a home energy assessment can satisfy.
My duplex in the village has no ductwork. What works here?
Ductless mini-splits are the standard answer for village-density Erving homes. They sidestep the ductwork problem and route through one wall penetration per zone, which is friendly to attached or near-attached construction.
Do I need a permit?
Yes. The Erving building department requires a permit for any HVAC system replacement, and a separate electrical permit for new heat-pump circuits.
Will the Conservation Commission be involved?
Often yes, especially for homes near the Millers River. Any equipment work inside the 100-foot wetlands buffer typically needs a Notice of Intent — plan a few extra weeks for that review.
Where are most contractors based?
Most HVAC contractors serving Erving work out of Greenfield, Turners Falls, or Athol, all within reasonable drive time.

HVAC guides for Massachusetts homeowners

All HVAC guides →

HVAC contractors in nearby towns

WendellGillNorthfieldMontagueWarwickOrangeGreenfieldBernardston