Mass Home Comfort
Find contractors
HVAC · Gill, MA

HVAC in Gill, Massachusetts

Compare contractors serving Gill, Franklin County — call them directly, or send one request and let the ones who want the job come to you.

30 contractors serving Gill.

Contractors serving Gill

Claimed listings within 5 miles come first, then the rest by rating, then distance. Google ratings as of October 2026. How we list and rank contractors

Mass Save in GillEligible

Gill is in Eversource electric territory and fully Mass Save eligible. Whole-home cold-climate heat pump installs have typically qualified for up to $8,500 ($2,650 per ton) in recent rebate cycles; partial and single-zone mini-split installs usually land around $2,500–$6,000. A free Mass Save home energy assessment is the unlock for the larger rebates and for weatherization subsidies. Gill's mix of older farmhouses means the assessment often surfaces meaningful insulation and air-sealing work; the 0% HEAT Loan up to $25,000 (effective January 1, 2025) is widely used to bundle the HVAC and envelope work into one financed project.

Read next

HVAC in Gill — what to know

Permits in Gill

Massachusetts state code (780 CMR) requires a building permit for HVAC replacement, pulled through the Gill building department. A separate electrical permit is required for new heat-pump circuits. Gill operates a small part-time building department; confirm inspection availability when scheduling. Properties near the Connecticut River, Barton Cove, or Fall River require Conservation Commission review under the Wetlands Protection Act for any work inside the 100-foot buffer — that's a wide swath of town given the river frontage.

Where a permit is required, HVAC work in Gill is filed with the Gill Building Department; see the Gill Building Department’s contact, portal and who pulls the permit on permits.llc.

Typical project cost

Gill HVAC costs sit near western-MA averages. A whole-home cold-climate heat pump retrofit typically runs $20,000–$34,000 before rebates; a single-zone ductless mini-split lands $4,500–$8,000; an oil boiler swap is usually $8,500–$13,000 with a new tank. Older river-valley farmhouses with stone foundations and balloon framing sometimes add $3,000–$6,000 for electrical and insulation prep work.

About Gill homes

Gill is a Franklin County town of about 1,747 people in roughly 647 housing units, set on the Connecticut River across from Turners Falls. The median home age is around 58 years, with the mix ranging from 18th- and 19th-century river-valley farmhouses to mid-century capes and ranches along Route 2 and Main Road.

Natural gas service is absent through most of town. Oil and propane dominate existing heating, and the river-valley climate (slightly milder than the hill towns to the west) makes heat pumps especially well-suited for whole-home retrofits here.

Common questions — HVAC in Gill

Do Mass Save heat pump rebates apply in Gill?
Yes. Gill is served by an investor-owned electric utility, so homeowners qualify for the full Mass Save program: the whole-home heat pump rebate of $2,650 per ton (up to $8,500) when the heat pump becomes the only heating system, $1,125 per ton with a boiler or furnace kept as backup, and the 0 percent HEAT Loan up to $25,000. The equipment must be on the Mass Save qualified product list, and the whole-home rebate has weatherization conditions that a home energy assessment can satisfy.
My house is right on the Connecticut River. Anything special for permitting?
Yes. Outdoor equipment pads or refrigerant trenching inside 100 feet of the river typically require a Conservation Commission Notice of Intent under the Wetlands Protection Act. Plan an extra few weeks for that review.
Will a heat pump be enough for winters in Gill?
Cold-climate units rated to roughly -13°F handle Franklin County design days, and Gill's river-valley climate is slightly milder than the surrounding hill towns. Many homeowners still keep an oil or propane backup for the coldest few nights.
Do I need a permit?
Yes. The Gill building department requires a permit for any HVAC system replacement, and a separate electrical permit for new heat-pump circuits.
Where are most Gill HVAC contractors based?
Most serving Gill work out of Greenfield, Turners Falls, or Northampton. That keeps drive time reasonable for both quotes and service calls.

HVAC guides for Massachusetts homeowners

All HVAC guides →

HVAC contractors in nearby towns

ErvingGreenfieldNorthfieldMontagueBernardstonWendellLeydenShelburne