Erving, MA Contractors: HVAC, Roofing, Plumbing & More

Erving is a Franklin County town of about 1,631 people in roughly 757 housing units along the Millers River and Route 2 east of Greenfield. The median home is around 75 years old — older than most neighboring towns — reflecting the densely packed mill-village housing in Erving Center and along Route 2A, plus rural farmhouses and back-road camps along the Millers.

Natural gas service is essentially absent. Oil, propane, and wood dominate existing heating. The dense older housing in the village makes ductless mini-splits the dominant retrofit choice, while back-road homes more often go ducted.

Erving is in National Grid electric territory and fully Mass Save eligible. Whole-home cold-climate heat pump installs have typically qualified for up to $8,500 ($2,650 per ton) in recent rebate cycles; partial and single-zone mini-split installs usually land around $2,500–$6,000. A free Mass Save home energy assessment is the unlock for the larger rebates. Erving's older housing means the assessment almost always surfaces insulation, air-sealing, and sometimes knob-and-tube work. Mass Save weatherization rebates cover a large share of envelope work, and the 0% HEAT Loan up to $25,000 (effective January 1, 2025) is widely used for bundled projects.

Massachusetts state code (780 CMR) requires a building permit for HVAC replacement, filed with the Erving building department. A separate electrical permit is required for new heat-pump circuits. Erving runs a small department; confirm inspection availability when scheduling. The Millers River, Keyup Brook, and adjacent wetlands put much of town inside Conservation Commission jurisdiction, and Notice of Intent filings under the Wetlands Protection Act are common for equipment pads or trenching.

Building permits for work in Erving go through the Erving Building Department; see the Erving Building Department’s contact, portal and who pulls the permit on permits.llc.