Kitchen & Bath · Everett, MA

Kitchen & Bath in Everett, Massachusetts

Compare contractors serving Everett, Middlesex County — call them directly, or send one request and let qualified pros come to you.

50 contractors serving Everett — including 12 based in town.

Contractors serving Everett

Kitchen & Bath in Everett — what to know

Rebates & incentives

Everett is in National Grid electric and gas territory, which makes homeowners and condo owners eligible for the full Mass Save rebate program. The relevant kitchen and bath incentives include the heat pump water heater rebate at $750 (electric-to-HPWH) or $1,400 (gas-to-HPWH), plus the induction range pilots running $500–$1,000. These are processed as instant rebates through participating contractors. The federal 25C tax credit expired December 31, 2025 and no longer applies to 2026 remodel or equipment work.

For triple-decker condo associations, Mass Save also has a separate multi-family pathway with different incentive levels and a coordinated assessment for all units. Owners doing a unit-only remodel typically use the single-family residential pathway. A panel upgrade often becomes part of the kitchen budget in Everett because the original 60–100A services in older triple-deckers can't support induction range plus HPWH plus dishwasher plus AC without a load calc.

Permits in Everett

Everett requires a building permit through ISD for any kitchen or bath remodel involving cabinetry, structural changes, or layout work, plus separate plumbing, electrical, and gas permits from the licensed trades. Plumbing permits cover any fixture relocation, electrical covers the kitchen circuits (two 20A small-appliance, dishwasher, disposal, GFCI/AFCI), and gas covers any range or cooktop move. Nearly all Everett housing predates 1978, so federal RRP lead-paint rules apply to almost every job, adding $1,500–$5,000. Condo bylaws frequently require trustee or board approval before plumbing or wall changes — check your unit's master deed and rules before signing a contract. There is no historic district restricting interiors.

Typical project cost

Everett pricing runs in the higher-mid band — close to Boston-adjacent suburbs but typically 5–15% below Cambridge or Somerville. A cosmetic bath refresh in a triple-decker runs $5,000–$9,000 partly because of access and disposal logistics. A full mid-range bath gut lands $22,000–$36,000; the tight 5-by-7 footprint actually makes some triple-decker baths cheaper to gut than larger suburban baths, but plumbing-stack relocations can push that up fast. Pull-and-replace kitchens with semi-custom cabinets and quartz counters run $38,000–$68,000. High-end gut renovations with open-concept changes (often a load-bearing wall between kitchen and parlor) reach $80,000–$170,000 in condo conversions.

About Everett homes

Everett is one of the densest small cities in Massachusetts — about 49,000 residents on 3.4 square miles, with housing averaging around 80 years old. The defining building is the wood-frame triple-decker built between 1890 and 1930, and typical kitchen-and-bath work here means a 900–1,100 sq ft unit with 5-by-7 baths, narrow galley kitchens, plaster walls, and shared DWV stacks.

Gentrification accelerated after Encore Boston Harbor opened in 2019. Condo conversions of three-family buildings are common, and the market now includes investor-driven gut work alongside owner renovations. Orange Line access at Wellington pushes pricing toward the higher-mid band for the inner-Boston ring.

Common questions — Kitchen & Bath in Everett

Can I open the wall between my Everett triple-decker kitchen and parlor?
Often yes, but the wall is frequently load-bearing in a three-decker, and the work requires structural engineering, a new beam (often LVL), a building permit, and inspection. Budget $8,000–$20,000 for the structural piece alone in addition to finishes.
What rebates apply if I'm in a condo association?
National Grid is in Mass Save, so single-unit owners can access residential HPWH ($750/$1,400) and induction range rebates ($500–$1,000). Whole-building projects use the Mass Save multi-family pathway — your association's property manager can coordinate.
Do I need board approval before remodeling my Everett condo?
Almost always for any plumbing relocation, wall removal, or floor finish change. Check the master deed and bylaws — many associations require an architectural review form plus proof of contractor insurance. Cosmetic-only work is usually exempt.
My triple-decker has 100A service. Can it handle an induction range plus heat pump water heater?
Maybe. A licensed electrician should run a load calc. Many Everett triple-deckers need a panel and service upgrade ($3,500–$6,500) before a code-compliant install. The federal 25C credit expired December 31, 2025 and no longer applies to 2026 panel upgrades.
How long does a triple-decker bath gut take?
Plan 4–6 weeks of active work in a 5-by-7 bath once permits and materials are ready. Tight access from the street to a third-floor unit can add a week of demo and material-staging time.

Kitchen & Bath contractors in nearby towns