Electricians · Pembroke, MA

Electricians in Pembroke, Massachusetts

Compare contractors serving Pembroke, Plymouth County — call them directly, or send one request and let qualified pros come to you.

50 contractors serving Pembroke — including 3 based in town.

Contractors serving Pembroke

Electricians in Pembroke — what to know

Rebates & incentives

Pembroke is in Eversource territory, so homeowners are fully Mass Save eligible. There's no direct electrical rebate, but a 200-amp panel upgrade is usually the prerequisite for a Mass Save heat pump or heat-pump water heater, and for a Level 2 EV circuit. Many Pembroke homes from the 1960s-80s have 100-amp service that needs upgrading first.

For the older 1960s-70s homes, the aluminum-branch-wiring question is worth raising; it's an insurance and fire concern best handled alongside a planned panel upgrade. The panel work unlocks the Mass Save rebate rather than being rebated itself.

Permits in Pembroke

Electrical work in Pembroke requires a permit under 527 CMR 12.00, the Massachusetts amendments to the NEC, and a licensed Journeyman or Master electrician. Permits go through the Pembroke Building Department, with the town wiring inspector inspecting before energizing. Panel upgrades, EV circuits, generator transfer switches, and aluminum-wiring remediation all require the permit. Service upgrades are coordinated with Eversource for disconnect and reconnect. Like-for-like device swaps are exempt.

Typical project cost

Pembroke sits in the South Shore band, with rates below Boston metro and above central Massachusetts. A 100-to-200-amp panel upgrade typically runs $2,500–$4,500. A Level 2 EV charger circuit usually lands $900–$2,300. Aluminum-branch remediation ranges from a few hundred dollars for pigtailing to $10,000+ for a partial rewire. A whole-home generator with transfer switch commonly runs $8,000–$16,000, a frequent install given Pembroke's storm-prone wooded neighborhoods.

About Pembroke homes

Pembroke is a Plymouth County town of about 18,330 residents and 6,809 housing units, with a median build age near 49 years. The housing is largely 1960s-through-1990s single-family homes spread across wooded and pond-side neighborhoods, with older stock near the village centers.

That profile keeps the electrical work practical: 100-amp panel upgrades to 200 amps, EV charger circuits for the larger suburban lots, and standby generator wiring, which sees steady demand in Pembroke because storms regularly knock out power across the wooded South Shore. Aluminum branch wiring shows up in some of the 1960s-70s homes.

Common questions — Electricians in Pembroke

Are generators common in Pembroke?
Yes. Pembroke's wooded South Shore neighborhoods lose power in nor'easters and summer storms, so standby generators with automatic transfer switches are a frequent install, typically $8,000–$16,000. A licensed electrician wires the transfer switch and pulls the permit.
Do I need a 200-amp panel for a Mass Save heat pump in Pembroke?
Usually yes. Pembroke is Eversource territory and Mass Save eligible, but many homes here have 100-amp service that can't carry a heat pump's load, so a 200-amp upgrade comes first.
Could my 1970s Pembroke home have aluminum wiring?
Possibly. Aluminum branch wiring appears in some late-1960s and 1970s homes and is an insurance and fire concern. An electrician can pigtail it with approved connectors or recommend a partial rewire.
Is Pembroke Mass Save eligible?
Yes. Pembroke is served by Eversource, so you qualify for Mass Save heat pump and heat-pump water heater rebates. The panel upgrade is the enabling step, not a rebated item.
Do I need a permit for a generator hookup in Pembroke?
Yes. Generator and transfer-switch wiring requires an electrical permit under 527 CMR 12.00 and a licensed electrician, with the Pembroke wiring inspector signing off before it's energized.

Electricians contractors in nearby towns