Mass Home Comfort
Find contractors
Electricians · Rockland, MA

Electricians in Rockland, Massachusetts

Compare contractors serving Rockland, Plymouth County — call them directly, or send one request and let qualified pros come to you.

50 contractors serving Rockland — including 2 based in town.

Contractors serving Rockland

Electricians in Rockland — what to know

Rebates & incentives

Rockland is in Eversource territory, so homeowners are fully Mass Save eligible. There's no direct electrical rebate, but a 200-amp panel upgrade is usually the prerequisite for a Mass Save heat pump or heat-pump water heater, and for a Level 2 EV circuit. A lot of Rockland's post-war homes still carry 100-amp service that needs upgrading first.

For 1960s-70s homes, the aluminum-branch-wiring question is worth raising; it's an insurance and fire concern best handled with a planned panel upgrade. The panel work unlocks the Mass Save rebate rather than being rebated itself.

Permits in Rockland

Electrical work in Rockland requires a permit under 527 CMR 12.00, the Massachusetts amendments to the NEC, and a licensed Journeyman or Master electrician. Permits go through the Rockland Building Department, with the town wiring inspector inspecting before energizing. Panel upgrades, EV circuits, generator transfer switches, and aluminum-wiring remediation all require the permit. Service upgrades are coordinated with Eversource for disconnect and reconnect. Like-for-like device swaps are exempt.

Typical project cost

Rockland sits in the South Shore band, with rates below Boston metro and above central Massachusetts. A 100-to-200-amp panel upgrade typically runs $2,400–$4,400. A Level 2 EV charger circuit usually lands $850–$2,200. Aluminum-branch remediation ranges from a few hundred dollars for pigtailing to $10,000+ for a partial rewire. A whole-home generator with transfer switch commonly runs $8,000–$15,000.

About Rockland homes

Rockland is a Plymouth County town of about 17,721 residents and 7,317 housing units, with a median build age near 62 years. The stock is mostly post-war and mid-century single-family homes on modest lots, a denser pattern than the larger-lot South Shore towns nearby.

That era of building means 100-amp fuse and breaker panels are common in Rockland, with aluminum branch wiring turning up in some 1960s-70s homes. The bread-and-butter work is 200-amp service upgrades, EV charger circuits, AFCI/GFCI updates, and heat-pump enablement, with generator wiring on the larger-lot homes.

Common questions — Electricians in Rockland

Is my Rockland home likely to need a panel upgrade for a heat pump?
Often yes. With a median home age near 62 years, many Rockland homes have 100-amp service. Rockland is Eversource territory and Mass Save eligible, but a 200-amp upgrade usually has to come first to carry the load.
Could my 1970s Rockland home have aluminum wiring?
Possibly. Aluminum branch wiring appears in some late-1960s and 1970s homes and is an insurance and fire concern. An electrician can pigtail it with approved connectors or recommend a partial rewire.
Is Rockland Mass Save eligible?
Yes. Rockland is served by Eversource, so you qualify for Mass Save heat pump and heat-pump water heater rebates. The panel upgrade is the enabling step, not a rebated item.
What does an EV charger circuit cost in Rockland?
Typically $850–$2,200 depending on the run from the panel. A licensed electrician pulls the permit and the Rockland wiring inspector signs off before it's energized.
Do I need a permit to upgrade my panel in Rockland?
Yes. A panel or service upgrade requires an electrical permit under 527 CMR 12.00 and a licensed electrician, with the Rockland wiring inspector signing off before the new service is energized.

Electricians contractors in nearby towns

AbingtonHanoverWhitmanHolbrookNorwellWeymouthHansonEast Bridgewater