Fencing · Hanson, MA

Fencing in Hanson, Massachusetts

Compare contractors serving Hanson, Plymouth County — call them directly, or send one request and let qualified pros come to you.

50 contractors serving Hanson.

Contractors serving Hanson

Fencing in Hanson — what to know

Rebates & incentives

Fencing carries no Mass Save or energy rebate in Hanson because a fence is not an energy-efficiency measure, so there is nothing to apply for either way. What actually governs your project is local zoning. Hanson typically caps rear and side-yard fences around 6 feet, with lower limits (often about 4 feet) in the front-yard setback, and the building department confirms the exact figures and setbacks at permit time. Hanson sits on Eversource, an investor-owned utility, so the MLP question never comes up here. The bigger constraint is water: Hanson has extensive wetlands, cranberry bogs, and pond frontage, so any fence within roughly 100 feet of a resource area can trigger Conservation Commission review under the Wetlands Protection Act. Pools require a barrier at least 4 feet high with self-closing, self-latching gates.

Permits in Hanson

Most fences in Hanson need a building or zoning permit from the town building department, and the residential contractor doing the work must hold a Massachusetts Home Improvement Contractor (HIC) registration. Plan for posts set on footings reaching roughly 48 inches below grade to clear the New England frost line, which matters in Hanson's sandy and sometimes wet soils. Have your property lines confirmed before anyone digs, since older rural lots here often have fuzzy boundaries, and call Dig Safe (811) before any post hole goes in. If your yard borders a bog, pond, or wetland, expect a Conservation Commission step first.

Typical project cost

Fence costs in Hanson sit a bit below the Boston-metro peak but reflect southeastern Massachusetts labor rates. Pressure-treated and cedar privacy fence runs roughly $35-$60 per linear foot installed; vinyl/PVC privacy runs about $45-$75; chain-link is roughly $20-$35; split-rail or post-and-rail is around $20-$40. A standard pool-barrier aluminum fence often lands near $40-$65 per foot. Wet or sandy soil that complicates post setting, long runs across the larger Hanson lots, and gate count are the main cost drivers.

About Hanson homes

Hanson is a small Plymouth County town of about 10,619 people across roughly 4,143 housing units, with a median home age near 54 years. Development here runs to mid-century ranches and capes on wooded lots, many a half-acre or larger, with newer subdivisions filling in around them.

That suburban-rural mix drives the fencing work. Rear-yard cedar and vinyl privacy fences are common on the larger lots, while chain-link and split-rail show up around the more open parcels and along the cranberry bogs and pond edges that thread through town. Pool-barrier fencing is a steady request given the in-ground pools on these bigger yards.

Common questions — Fencing in Hanson

Do I need a permit to put up a fence in Hanson?
In most cases yes. Hanson requires a building or zoning permit for fences through the town building department, and your installer should hold a Massachusetts HIC registration. The department also confirms height and setback limits for your specific lot.
How tall can my backyard fence be in Hanson?
Rear and side-yard fences are typically allowed up to about 6 feet, with a lower limit (often around 4 feet) in the front-yard setback. Confirm the exact numbers with the Hanson building department before you order materials.
My yard backs up to a cranberry bog. Does that change anything?
It can. Any fence within roughly 100 feet of a bog, pond, or wetland may need Hanson Conservation Commission review under the Wetlands Protection Act before the building permit issues. Flag it early so it does not stall your project.
What are the rules for fencing my pool in Hanson?
Massachusetts building code requires a pool barrier at least 4 feet high with self-closing, self-latching gates. On Hanson's larger lots, homeowners often fence the immediate pool area rather than the whole yard to meet the code at lower cost.
How deep do fence posts need to go in Hanson?
Set posts on footings reaching about 48 inches below grade to get below the frost line. Hanson's sandy and sometimes wet soils make proper depth and compaction important so posts do not heave or lean over winters.