N&T Mechanical Contractors, Inc.

Plumbing in Sterling, MA · ★ 5.0 Google rating

Google rating as of October 2026. How ratings work here

Address
86 Leominster Rd Suite 1, Sterling, MA 01564

Skip the phone calls

Describe your project once, and local contractors who want the job contact you directly. You choose how many.

Find Plumbing contractors in Sterling

About N&T Mechanical Contractors, Inc.

N&T Mechanical Contractors, Inc. is a Plumbing contractor based in Sterling, Worcester County, Massachusetts, at 86 Leominster Rd Suite 1, Sterling, MA 01564. It has a Google rating of 5.0 out of 5. Its website is linked above. A listing here is not a license or insurance check, so verify both directly before hiring.

Service area

Based in Sterling, N&T Mechanical Contractors, Inc. is within a short drive of Clinton (4 mi), West Boylston (5 mi), Lancaster (5 mi), Leominster (6 mi), Boylston (6 mi) and Princeton (6 mi). Most Massachusetts plumbing contractors work a 25-mile radius, so homeowners in those towns can reasonably ask for a quote.

Hiring a Plumbing contractor in Sterling

Massachusetts requires a licensed plumber and a plumbing permit for water-heater replacement, repiping, well-pump and pressure-tank work, drain and sewer lines, and rough-ins; gas and tankless work needs a licensed gas fitter and a separate gas permit. Sterling issues these through its Building Department and plumbing/gas inspector, with inspection before closing. Because the town borders the Wachusett Reservoir watershed protected by DCR, septic and ground-disturbing or wetland-adjacent work can involve the Board of Health and Conservation Commission, so confirm requirements first.

Sterling sits in the central MA market, where plumbing labor runs below Boston-metro and North Shore rates. A tank water heater typically runs $1,700–$2,900 installed; a heat-pump water heater $2,600–$4,300 before any municipal-utility rebate; tankless gas $3,800–$6,400 with venting. Repiping an older village home in copper or PEX commonly lands $7,000–$14,000 depending on access. Well work adds cost — a pressure tank a few hundred to over a thousand, a submersible pump $1,500–$3,500 with the pull.

Massachusetts requires a written contract and a Home Improvement Contractor registration for most residential plumbing work; ask for the registration number and check it before paying a deposit.

More on permits, costs, rebates and common questions, plus every other plumbing contractor serving the town, on the Plumbing in Sterling page.

See all Plumbing in Sterling.