Shirley, MA · Middlesex County

Shirley, MA Contractors: HVAC, Roofing, Plumbing & More

Middlesex County · pop. 7,092. Pick a trade below to see contractors serving Shirley.

Updated

Ready to schedule?

Book an in-home estimate in Shirley online. Pick the kind of work to see the times.

See times

Skip the phone calls

Describe your project once, and local contractors who want the job contact you directly. You choose how many.

Find local contractors

About hiring in Shirley

From our HVAC in Shirley page; each trade page has its own permit and cost notes.

Shirley at a glance

Shirley is a Middlesex County town in the Nashoba Valley, home to about 7,092 people across roughly 2,566 housing units. The median home is around 49 years old — among the younger housing stocks in the region — reflecting suburban growth from the 1960s and 1970s alongside older village houses near the town center and the former Shirley Shaker village.

Many Shirley homes are forced-air ranches, Colonials, and split-levels built with gas or oil furnaces, with some properties on propane. The typical HVAC job is replacing an aging furnace or boiler, and because a good share of homes already have ductwork, ducted heat pumps are a practical option alongside ductless mini-splits for the older, ductless houses near the village.

Mass Save in Shirley

Shirley homes are served by National Grid for electricity, an investor-owned utility, so residents are eligible for the complete Mass Save rebate program. In recent rebate cycles, whole-home heat pump retrofits that replace fossil-fuel heat have qualified for up to $8,500 ($2,650 per ton) back after a home energy assessment, with ductless and partial systems earning smaller rebates. National Grid customers can book a free Mass Save Home Energy Assessment, which is normally the path to the largest rebates and to deeply subsidized insulation and air-sealing. Shirley's mid-century homes often have thin original insulation, so the air-sealing and insulation work that comes out of the assessment frequently pays for itself fast and helps a new heat pump perform.

Permits in Shirley

Under the Massachusetts building code, any HVAC system replacement in Shirley requires a permit through the town building department, and a separate electrical permit covers the new circuits a heat pump needs. Licensed contractors normally pull and close out both. For homes near the historic Shirley Shaker village or the town center, confirm outdoor condenser placement with the building department before the install so visible siting doesn't become an issue.

Building permits for work in Shirley go through the Shirley Building Department; see the Shirley Building Department’s contact, portal and who pulls the permit on permits.llc.