Phillipston, MA · Worcester County

Phillipston, MA Contractors: HVAC, Roofing, Plumbing & More

Worcester County · pop. 1,918. Pick a trade below to see contractors serving Phillipston.

Updated

Ready to schedule?

Book an in-home estimate in Phillipston online. Pick the kind of work to see the times.

See times

Skip the phone calls

Describe your project once, and local contractors who want the job contact you directly. You choose how many.

Find local contractors

About hiring in Phillipston

From our HVAC in Phillipston page; each trade page has its own permit and cost notes.

Phillipston at a glance

Phillipston is a rural Worcester County town of about 1,918 people and 835 housing units, tucked between Athol and Templeton off Route 2A. The median home age is around 43 years, reflecting heavy 1970s–80s build-out along the back roads — ranches, raised ranches, and capes on wooded acre-plus lots are the dominant pattern.

Natural gas service is essentially absent in Phillipston. Most homes run on oil, propane, or a mix including wood. The relatively young housing stock means existing forced-air ductwork is common, which is unusual for a small rural MA town and makes ducted heat pump retrofits a straightforward upgrade path.

Mass Save in Phillipston

Phillipston is in National Grid electric territory, so homeowners qualify for the full Mass Save rebate program. Whole-home cold-climate heat pump installs have typically earned up to $8,500 ($2,650 per ton) in recent rebate cycles; partial and single-zone installs usually run $2,500–$6,000. A Mass Save home energy assessment, which is free for National Grid customers, is the gatekeeper for the larger rebates. Many Phillipston homes are good candidates for ducted heat pumps because the existing furnace already has duct runs. The 0% HEAT Loan up to $25,000 (effective January 1, 2025) is a common pairing — it covers the unrebated balance plus weatherization on attic and crawlspace insulation, which often shows up as the highest-ROI piece of the project.

Permits in Phillipston

Massachusetts state code (780 CMR) requires a building permit for HVAC replacement in Phillipston, filed with the town building department. A separate electrical permit is required for new heat-pump circuits. Phillipston is a small town with part-time building department hours, so contractors should confirm inspection scheduling before promising tight install windows. Work near Queen Lake or any of the brooks feeding the Millers River watershed may require a Conservation Commission Notice of Intent if it falls inside the 100-foot wetlands buffer.

Building permits for work in Phillipston go through the Phillipston Building Department; see the Phillipston Building Department’s contact, portal and who pulls the permit on permits.llc.