Mass Home Comfort
Find contractors
Electricians · Mattapoisett, MA

Electricians in Mattapoisett, Massachusetts

Compare contractors serving Mattapoisett, Plymouth County — call them directly, or send one request and let the ones who want the job come to you.

30 contractors serving Mattapoisett — including 1 based in town.

Contractors serving Mattapoisett

Claimed listings within 5 miles come first, then the rest by rating, then distance. Google ratings as of October 2026. How we list and rank contractors

Electricians in Mattapoisett — what to know

Rebates & incentives

Mattapoisett is in Eversource territory, so homeowners qualify for Mass Save. Electrical panel work has no standalone rebate, but a 200-amp service upgrade is usually the step that makes a Mass Save heat-pump or heat-pump water heater rebate achievable — and many seasonal homes here have service that's too light for those loads.

The same upgrade enables a Level 2 EV charger circuit. For older village homes still on knob-and-tube or a 60A fuse box, rewiring is worth doing on its own: insurers increasingly decline coverage on that wiring, and a coastal home with corroded service gear is a renewal risk.

Permits in Mattapoisett

Electrical work in Mattapoisett requires a permit under 527 CMR 12.00 and a licensed Journeyman or Master electrician; only like-for-like device swaps may skip the permit. The town's wiring inspector signs off before energizing. Near the harbor and the Wetlands-protected shoreline, service-entrance and outdoor equipment work may intersect with conservation rules, and the utility coordinates any meter or service-mast change. Build in extra time for inspections during the busy summer season, when the town's seasonal population swells and inspector schedules tighten.

An electrical permit in Mattapoisett is filed with the town’s wiring inspector; see the Mattapoisett Building Department’s contact, portal and who pulls the permit on permits.llc.

Typical project cost

Mattapoisett sits on the South Coast, where labor runs moderate — below Boston metro and the Cape, roughly in line with greater New Bedford. A 100A-to-200A panel upgrade typically runs $2,500–$4,500, often at the higher end when corroded coastal service gear has to be replaced too. A Level 2 EV circuit usually lands $700–$2,000. A knob-and-tube or aluminum rewire of an older village home ranges $10,000–$25,000. A standby generator with transfer switch — popular here for storm and nor'easter outages — generally runs $10,000–$18,000 installed.

About Mattapoisett homes

Mattapoisett is a Plymouth County coastal town of about 6,511 residents and roughly 3,607 housing units, with a median build age near 52 years. The high housing-unit count relative to population reflects a sizable share of seasonal and second homes along the harbor and out toward Ned's Point.

Salt air is the local electrical wrinkle here: meter sockets, service masts, and outdoor disconnects corrode faster near the water, and panels in summer homes that sit idle half the year tend to age hard. Older village homes off Water Street also carry the knob-and-tube and undersized-fuse-panel issues common to the region.

Common questions — Electricians in Mattapoisett

Does salt air really affect my electrical service in Mattapoisett?
Yes. Homes near the harbor see faster corrosion on meter sockets, service masts, and outdoor disconnects. Electricians here often spec corrosion-resistant or marine-rated gear, and a service upgrade is a good time to replace pitted equipment.
My summer home has an old fuse panel — should I upgrade it?
If it's a 60A or 100A fuse box, upgrading to a 200A breaker panel is usually worth it. It removes the insurance red flag, supports a heat pump or EV charger, and replaces gear that ages hard sitting idle through humid coastal off-seasons.
Can I get Mass Save rebates in Mattapoisett?
Yes — the town is Eversource territory, so you're Mass Save eligible. There's no panel rebate, but upgrading to 200A service is often what makes a heat-pump or heat-pump water heater rebate physically possible on an older home.
Do I need a permit for a generator hookup?
Yes. A standby generator and transfer switch require an electrical permit under 527 CMR 12.00 and a licensed electrician, with the Mattapoisett wiring inspector signing off. Generators are common here for storm outages, so most local electricians do them routinely.
How long do inspections take in the summer?
Plan for some lag. Mattapoisett's seasonal population swells in summer and the wiring inspector's schedule fills up, so booking permitted work in spring or fall often means faster turnaround.

Electricians guides for Massachusetts homeowners

All Electricians guides →

Electricians contractors in nearby towns

FairhavenMarionAcushnetNew BedfordRochesterWarehamDartmouthFalmouth