Electricians · Holland, MA

Electricians in Holland, Massachusetts

Compare contractors serving Holland, Hampden County — call them directly, or send one request and let qualified pros come to you.

50 contractors serving Holland — including 2 based in town.

Contractors serving Holland

Electricians in Holland — what to know

Rebates & incentives

Holland is served by National Grid, an investor-owned utility, so homeowners are fully Mass Save eligible. There's no direct electrical rebate, but a 200-amp panel upgrade is usually the prerequisite for a Mass Save heat pump or heat-pump water heater — and many year-round Holland homes started as camps with electrical service too small for modern heating loads.

When a former cottage gets a heat pump, the panel almost always has to be upgraded first, and a 200-amp service also supports EV charging and a standby generator. Older converted camps may carry early wiring an insurer flags, so remediation sometimes pairs with the upgrade. Confirm current Mass Save figures before scheduling, since they change between cycles.

Permits in Holland

Electrical work in Holland requires a permit under 527 CMR 12.00, the Massachusetts amendments to the NEC, and a licensed Journeyman or Master electrician. Permits run through the Holland Building Department, and the town wiring inspector inspects before energizing. Camp rewires, panel upgrades, EV circuits, and generator transfer switches all require the permit. Work near Hamilton Reservoir's shoreline may trigger conservation commission review under the Wetlands Protection Act. Service changes are coordinated with National Grid for disconnect and reconnect.

Typical project cost

Holland sits in the western/south-central MA band, where labor runs below eastern Massachusetts. A 100-to-200-amp panel upgrade typically runs $2,200–$4,000. A Level 2 EV charger circuit usually lands $800–$2,000. Upgrading a former lake camp's wiring to year-round standards can run $6,000–$18,000 depending on its condition. A standby generator with transfer switch commonly runs $7,500–$15,000.

About Holland homes

Holland is a small Hampden County town on the Connecticut border, built around Hamilton Reservoir, with about 2,585 residents and 1,552 housing units — a high housing count for the population because so much of the stock is former lake camps. The median build age is near 48 years, younger than the old mill towns, but many properties started as seasonal cottages later converted to year-round use.

That lake-camp history drives the electrical work. Converted cottages often have undersized panels and dated wiring not built for winter, overhead drops cross wooded lots, and storms cause outages. Service upgrades, camp rewires, and generator hookups are the steady jobs in Holland.

Common questions — Electricians in Holland

I'm converting a Hamilton Reservoir camp to year-round — what's needed?
Many Holland camps have undersized panels and dated wiring not built for winter loads. A licensed electrician typically upgrades the service to 200 amps and brings circuits up to 527 CMR 12.00 before you add a heat pump or electric heat.
Is Holland Mass Save eligible?
Yes. Holland is on National Grid, an investor-owned utility, so you qualify for Mass Save heat pump and heat-pump water heater rebates. A 200-amp panel upgrade is usually the step that unlocks them on a former camp.
Do I need conservation approval for shoreline electrical work?
The electrical permit under 527 CMR 12.00 is always required. If trenching or a generator pad sits near Hamilton Reservoir's shoreline, the Holland Conservation Commission may need to review it under the Wetlands Protection Act.
Should I add a generator at my Holland lake house?
Many homeowners do, since storms cut power and a well pump stops without it. A licensed electrician installs a transfer switch under permit so the generator can't backfeed National Grid's lines.
How much is a panel upgrade in Holland?
A 100-to-200-amp upgrade typically runs $2,200–$4,000 in this part of Hampden County. A converted camp with degraded wiring can cost more if circuits need rework alongside the new service.