Heath, MA Contractors: HVAC, Roofing, Plumbing & More

Heath is a small Franklin County hilltown on the New Hampshire border — about 719 residents and 602 housing units, with a meaningful seasonal-home share. Median construction year is in the late 1970s, but the housing mix runs from 1800s farmhouses around the village to 1970s–80s rural ranches and capes on dirt roads.

No natural gas distribution reaches Heath. Wood, oil, and propane carry most of the heating load, and the town has one of the higher per-capita rates of cordwood use in MA. The combination of older stock, no gas, and high winter heating demand is exactly the profile Mass Save rebates were designed to address.

Heath is served by National Grid for electricity, so homeowners qualify for the full Mass Save rebate program. Whole-home heat pump retrofits have typically qualified for up to $8,500 ($2,650 per ton) in rebates after a free Home Energy Assessment in recent cycles; partial systems and ductless mini-splits run $1,250–$6,250. For older Heath farmhouses, the Home Energy Assessment is the unlock — Mass Save's weatherization measures (often 75–100% subsidized) usually deliver more comfort per dollar than the heat pump itself. Sequencing matters: assessment, weatherization, then heat pump sized to the post-weatherization load.

Heath requires a building permit for HVAC system replacement through the town building inspector on part-time hours. Heat pump installs need a separate electrical permit. Conservation Commission jurisdiction applies near the Deerfield River and its tributaries — work within the 100-foot wetland buffer requires a Notice of Intent under the Wetlands Protection Act. Properties in the rural-residential zoning district have generous setbacks, so outdoor unit placement rarely runs into setback issues.

Building permits for work in Heath go through the Heath Building Department; see the Heath Building Department’s contact, portal and who pulls the permit on permits.llc.