Electricians in Dedham, Massachusetts

Dedham is in Eversource electric territory, so homeowners qualify for Mass Save. There's no direct rebate for the electrical work, but a 200A panel upgrade is usually the prerequisite before a Mass Save air-source heat pump or heat-pump water heater can go in — older Dedham services often can't carry a heat pump plus existing load.

Knob-and-tube remediation carries a second benefit here: with so much pre-1950 housing, Boston-area carriers frequently surcharge or decline policies on active knob-and-tube, so rewiring helps on the insurance side independent of any energy program. A free Mass Save home energy assessment is the usual starting point.

Electrical work in Dedham requires a permit under 527 CMR 12.00, the Massachusetts amendments to the National Electrical Code, performed by a licensed Journeyman or Master electrician. Permits are filed with the Dedham Building Department and the town wiring inspector inspects the work before it's energized. Panel upgrades, EV circuits, generators, and rewires all need permits; like-for-like device swaps generally don't. Properties in Dedham's historic districts around the square may face additional review for visible exterior changes such as a relocated meter or service mast.

Dedham pricing reflects the inner Boston metro market. A 100A-to-200A panel upgrade typically runs $2,800–$5,200, more when an old service entrance or meter socket needs rebuilding. A Level 2 EV-charger circuit usually lands at $1,000–$2,300 depending on the run to the garage. Knob-and-tube rewiring is priced by accessibility and often falls between $8,000 and $18,000 for a full house. A whole-home generator with a transfer switch generally runs $8,500–$15,000 installed.

Dedham has about 10,885 housing units in Norfolk County, and the median home here was built roughly 71 years ago. The town's housing runs from pre-Revolutionary and Victorian homes around Dedham Square and the historic Avery Oak area to dense postwar neighborhoods in Oakdale and Riverdale.

That older core means a lot of original 60A and 100A fuse panels and active knob-and-tube wiring still in service. As homeowners add EV chargers and electrify heating, those panels become the limiting factor, so service upgrades and partial rewires are the bread-and-butter electrical jobs in town.